Document
If you are experiencing No/Low Spray to the hose, follow these steps to resolve:
Turn off and unplug machine
- Remove Hose & keep machine in the upright position
- Clean the spray tip at the end of the hose with a soft brush (old toothbrush)
Remove the front nozzle by lifting under the hose access door and pulling up
- To Prime, use a standard ball point pen to press into the small circular opening until water
comes out
- Place the pen in the black cylinder next to the screw
- When water bubbles up, remove the pen
- Reassemble the nozzle
- Line up the three hooks on the nozzle to the bottom of the foot
- Machine may have to be leaned back slightly to install correctly
- Rotate the nozzle up and click into place
- Reinsert the hose
- Be sure the colored hose release clip is facing out, away from machine
- Keep the hose below the upper water tank or lay hose flat on the floor
- Remove tool at the end of the hose
- Plug machine in and turn on
- Retry pressing hose trigger for up to 20 seconds while machine is on – it may blow out pockets of air
- Is there spray coming out of the spray tip?
- No > Go to Changing the Belt
- Yes > Reattach tool and test for spray with tool
- Is there spray with tool?
- Yes > Great! Glad we could get you back to cleaning!
- No > A new tool should be ordered > Go to Parts & Supplies
- Is there spray with tool?
Was this answer helpful?
If you are experiencing weak or no spray from your hose and tool on your ProHeat 2X Revolution Pet Pro, here are a few tips that may help:
- First, check to make sure the hose is tightly attached to the machine
- Press on the base of the hose to ensure it is secured
- Also, check to make sure the tool you're using is tightly attached to the hose
- If you are experiencing low or absence of spray from the hose your hose may not be primed or may have lost Prime
- First, turn your machine off and unplug it
- Next, remove the nozzle from the foot
- To do this, scoop and grip the accessory hose door and pull up on the nozzle until it releases
- Place a ballpoint pen in the black cylinders next to the screw
- When water bubbles up remove the pen
- Now put the nozzle and hose back into place
- Hold the end of the hose below the water level in the tank to prime
- With a full tank of water and the Machine off and reclined press the clean shot button 'on'
- Wait for the clean shot to run for a few seconds, this will reprime your machine
- Your hose and tool also won't spray if the clean water tank is empty
- If you notice your clean tank is running low or is empty you will need to refill it to continue cleaning
- If you've refilled your clean water tank, be sure the tank is put back correctly
- If the tank is not secured this could also lead to weak or no spray coming from the hose of the machine
- Now you're ready to get back to cleaning with your Revolution Pet Pro
Using Hose & Tool | How to Videos | ProHeat 2X® Revolution®
Use the power of heat and enjoy a deep clean with the ProHeat 2X® Revolution®
When utilizing the tool, make sure that the machine is secure in the upright position.
Attach the desired tool to the end of the hose.
Press the spray trigger button to spray the soiled area, then slowly move tool back and forth over the area.
Release the trigger to suck up dirty solution, work in small sections until the area is clean.
When finished cleaning, turn the machine on to suction up warm clean water to rinse the inside of the tool.
Detach the hose and tool and close the accessory hose door. Let the hose and tool air dry before storing.