Schlage camelot electronic keypad single cylinder deadbolt manual

Keypad Deadbolt

Model BE365

Place Label Here

Default Codes

Tools Needed

• Phillips screwdriver
• Tape Measure
• Pencil

Optional

• Flathead Screwdriver
• Wood Block
• Hammer

Additional Parts

Installation Instructions

Prepare for Installation

IMPORTANT NOTES

• DO NOT use a power drill for installation!
• Use a screwdriver to remove a product from packaging.
• Install and test lock with door open to avoid being locked out.
• Pay special attention to step 1. If the lock is installed with the cam in the wrong position, the lock will not function properly!

a Check door dimensions.

See consumer.schlage.com/Service-Support for door preparation instructions if dimensions are different.

b Adjust bolt length, if necessary.

Measure the dimension shown. If the measurement is 2C\v” (70 mm), extend the bolt.

c Change faceplate, if necessary.

hoose the drawing that matches your door edge. If the hole has no mortise, change to the circular faceplate.

Install Lock

1. Rotate baseplate cam to correct position.
   
   
   
   
2. Install bolt.
   
   
   
   
3. Install keypad.
   
   
   
   
4. Route wire through a hole in baseplate.
   
   
5. Install baseplate.
   
   
6. Connect wire and 9V battery.
   
   
7. Place battery in holder and tuck wires.
   
   
8. Install cover.
   
   
9. Install reinforcement plate and strike into door jamb.
   
   

Test Lock

a Lock (extend bolt).

For troubleshooting information, go to schlage.com/faqs-keypad.

b Unlock (retract bolt).

Quick Programming Reference

More Programming, Warranty, and Registration Information

© Allegion 2018
Printed in U.S.A.
23780000 Rev. 06/18-f

Documents / Resources

References